Samsung Bluetooth Headset GH68 12459A User Guide

Before using your headset  
Check the accessories  
Charge your headset  
Thank you for purchasing the Samsung Bluetooth  
Mono Headset WEP180, we hope you will be  
delighted with its operation.  
Take a moment before you get started to  
familiarize yourself with your new headset.  
Make sure you have the following items with your  
headset:  
Charge the headset's battery fully before using  
the headset for the first time.  
3
Remove the travel adapter from the headset.  
Quick Start Guide  
Bluetooth® Headset  
WEP180  
Get connected in 4 quick steps  
NOTES:  
Travel adapter, User’s Guide, 1 ear hook  
1
Plug the travel adapter into the jack on the  
headset.  
• The headset cannot be used while charging.  
• Use only a Samsung-approved charger or adapter.  
Samsung  
NOTE:  
The items supplied with your headset and the accessories  
at your Samsung dealer may vary, depending on you  
country or service provider.  
Multi-Function  
Adapter jack  
button  
• Bluetooth version: 2.0 (compatible with devices of  
Bluetooth version 1.1 or higher)  
• Supported Bluetooth profiles:  
- Headset profile  
Charge your headset  
Earpiece  
Put your headset in pairing mode  
Turn on Bluetooth on your phone and  
pair with headset  
2
Plug the travel adapter into the electrical  
outlet.  
Indicator light  
Volume control  
- Hands-free profile  
• Charge the headset until the red light on the  
headset turns to blue.  
buttons  
Microphone  
Test and use  
• The headset will be fully charged in  
approximately 2 hours 30 minutes.  
Start here  
Put your headset in  
pairing mode  
Turn on Bluetooth on your  
phone and pair with headset  
Test and use  
Your phone and headset are now paired and  
ready to make and receive calls. To confirm  
they are operating properly, make a call:  
Before you can use your headset, you must pair it  
with your phone.  
1
Set your Bluetooth phone to discover the  
headset by following your phone's guide.  
Using your WEP180  
Headquarters:  
1301 East Lookout Drive Suite 150  
Richardson, TX 75082  
1
Place the headset over your ear.  
See Wearing the headset on the reverse  
side of this guide.  
Typically, the steps involve going to the Settings,  
Connection, or Bluetooth menu on your  
phone and then selecting the option to discover  
Bluetooth devices.  
1
2
Ensure that the headset is off (see Turn  
headset on/off on the reverse side of this guide).  
See Features and Functions Guide  
on the reverse side of this guide  
for information on using your  
WEP180.  
Internet Address:  
accessories  
Press and hold the Multi-Function button until  
the indicator light turns on in blue  
(approximately 8 seconds).  
2
3
On your phone, make a call to the number  
you want.  
Your phone will find the Samsung WEP180  
headset. your headset will be displayed as  
Samsung WEP 180/185.  
If your phone and headset are successfully  
paired, you will hear ringing on the headset.  
Customer Care Center:  
1-888-987-4357  
2
3
Select your headset.  
After you have successfully paired your phone  
and headset, you do not need to repeat these  
initial setup steps each time you use the  
headset.  
When the phone asks if you want to pair with it,  
confirm by selecting Yes or OK.  
4
Enter the headset passkey or PIN, 0000.  
Guide No.: GH68-12459A  
09/2006. Rev. 1.0  
 

PYLE Audio Speaker PSPVC4 User Guide
Raypak Swimming Pool Heater 992B 1532B User Guide
Rolls DJ Equipment MX28 User Guide
Samson Musical Table MXP124 User Guide
Samsung Flat Panel Television LC530 ZA User Guide
Samsung Video Game Controller ML 2250 User Guide
Sansui CRT Television SLED3200 User Guide
Sanyo Telephone SCP 4000 User Guide
Savin All in One Printer SDC326 User Guide
Sennheiser Car Satellite TV System EM 550 G2 User Guide